Insulation

Attic spaces may be serve as a nice living rooms. Insulation of pitched roof at relatively low cost is of great benefit. To do this, build in the spaces between the rafters in one or more layers polystyrene plates with a total thickness equal to the thickness of the rafters. The variant of roof insulation by placing EPS boards between the rafters. Go to Sammy Ofer for more information. Thermal insulation of walls, depending on the location of insulation in building envelope are the main options insulation heater located on the inside of the building envelope; insulation – inside the building envelope; Insulation – exterior cladding. In this case, the widely used two systems: the so-called system of "wet" type (with plastering or lining of the facade) and ventilated facades. 1) System with a heater on the inner side cladding Location insulation material on the inner surface of the walls of buildings is often only possible because – insulation can be made not at all, but only in certain areas of the building – the production of works on heat shield can be made at any time of the year, while, in contrast to the external insulation systems, do not need money podmaschivaniya – does not change in appearance of the buildings (so this method is often used for buildings with complicated facades in architectural terms of artistic or historical value). Unfortunately, the insulation walls on the inside has two significant drawbacks: – Reduction of floor space by increasing the thickness of the walls, partitions and ceilings, rigidly connected with the bearing wall and usually do not have a cut off insulating liner to form a frame building on the many thermal bridges. Therefore, in order to heat per unit area with insulation inside were equal heat loss with insulation on the outside, the thickness EPS boards must be at least 30 mm. – Thus lose part of the useful area of the interior.