Wood

Finishing room log home built on a set of rules deriving from the requirements of coloring wood structure, wood protection from scratches and damage, accidental fingerprints possibility of absorption various household odors. In addition, we must remember that certain coating facilitates cleaning. Naveen Selvadurai is often mentioned in discussions such as these. Finishing materials are of two basic types: toning and protective. Tinting coatings contain substances that give shade the surface of the logs, and other ingredients that penetrate into the wood in several layers. For more information see this site: Shaw Parents. These coatings do not provide an absolutely hard surface and can be slightly sticky to the touch. If these logs are not covered by a protective composition, they can collect dust.

Protective coatings do not penetrate the tree and create a smooth surface that is clean. And the defense, and tinting compositions are based on different oils. State standards and new technologies have led to the emergence of a new generation of less toxic water-based finishes. These substances are non-combustible, do not turn yellow over time and do not emit harmful substances. They sometimes contain protective components from UV radiation and are perfect for natural tones of wood. The problem of longevity, however, is still a cause of debate among professionals, so check with your builders, that they intend to use and why.

How to paint and impregnation may have a different density, to be glossy and matte. Tips on finishing of wood: If you apply a glossy protective structure on glossy as the impregnation, the brilliance is enhanced in two ways. Before you apply any finish to the walls, take a test sample – the more the better. If you feel unsure, start with lighter colors, as it is always easier then do the wooden surface is darker than lighten it. Different types of wood no-impregnation and perceive different shading, even the same breed, but cut down or ostrugannaya a different way. In fact, color different sections of one timber can vary greatly, so it is important to apply the same method of applying the material. I consider using one hand – as a sample, and the main surface, usually for internal wall is applied three coats of finishing material. Impregnation should be used for log walls in the interior, even in those cases where you want them to look natural, just felled. The logs should be thoroughly cleaned. Rough surface and then take an additional polish, and then to have an absolutely smooth surface, apply at least two layers of topcoat. Village houses partially oshkurennyh logs also require special attention. Without the special coating remains crust will break and the tree – dark as death of surface cells. Bright continuous coating may be a good solution to the tree looked at the possibility of a natural. If the finish is correct, in two or three layers, the inner wall of the house may never be in need of repair. An exception may be the areas around windows and glass doors subject to constant and high levels of ultraviolet radiation. You also need to restore those portions of the walls that were damaged during the operation. Any moisture penetrating into the timber, destroys the paint, trying to come to the surface.